Xuzhou Mingzun Electromechanical Co., Ltd.

News Details

Water Ingress, Insulation Drop and Sealing Maintenance

Published:2026-11-17 Views:22

After water enters a motor, common symptoms include reduced insulation, leakage, controller overcurrent protection, weak starting or abnormal noise. Hub motors, connectors and harnesses are at higher risk, and pressure washing, wading and long-term damp conditions accelerate seal aging.

Disconnect power immediately, open the motor to drain water and air-dry or use low-temperature warm air rather than baking the windings at high temperature. Measure winding-to-case insulation with an insulation tester and reassemble only after it returns to the normal range. Also inspect controllers and connectors for oxidation and corrosion.

Prevention matters more than repair: check oil seals, O-rings, cable grommets and end-cover sealant, route harness connectors upward with waterproofing, and avoid directing a pressure washer at the motor or controller. Replace aged seals promptly.

Previous:Sudden Range Loss: Battery, Low-Voltage Cutoff and Motor Efficiency
Next:Controller Wiring and Commissioning: Throttle, Brake, Meter and Learning Wires