Xuzhou Mingzun Electromechanical Co., Ltd.

News Details

Controller Wiring and Commissioning: Throttle, Brake, Meter and Learning Wires

Published:2026-11-17 Views:22

Before wiring a controller, disconnect power and remove the battery, then confirm capacitors are discharged. Thick red and black wires go to battery positive and negative; three thick phase wires go to the motor; the five-wire hall connector carries 5V, ground and three signals. Throttle, brake, meter, reverse, cruise and learning wires must follow the controller markings.

Connect power, phases and halls first, then throttle and brake, checking that plugs are fully seated and wire colors match. With the wheel lifted, turn on the key, trigger the learning wire or follow the commissioning procedure, and observe rotation direction and no-load current. Connect the meter and other function wires only after normal operation is confirmed.

Reversed battery polarity, shorting a 5V signal wire to battery voltage or poor phase contact can instantly damage the controller. Do not guess unmarked wires by color; check the controller documentation or verify with a multimeter. Keep a hand on the brake during commissioning so the vehicle cannot lunge forward.

Previous:Water Ingress, Insulation Drop and Sealing Maintenance
Next:E-Drive Matching and Maintenance for Heavy Loads and Climbs