
Start with payload, gradients and duty cycle, then check rated power, torque, sp

Overheating usually comes from overload, dragging brakes, excessive current limi

Voltage, current limit, phase sequence and hall angle must match; test unloaded

Hall faults cause juddering starts and power interruption; power the sensor with

Check power, signals and load in that order, and swap a known-good controller or

Bearing, gear, rotor-rub and electromagnetic noises differ; listen under no-load

Check tires, brakes, battery voltage under load and low-voltage cutoff first, th

Water ingress lowers insulation and triggers overcurrent protection; disconnect

Wire power, phases, halls, throttle and brake in order; complete self-learning u